山東創圖建筑裝飾工程有限公司
13165128506
您當前位置: 防火板用來隔墻具體方法
來源：http://www.hbzbdq.com/ 日期：2021-08-16 發布人：admin
使用的具體步驟：
Specific steps to use:
1。防火板：一般建議采用厚度大于6mm的玻璃鎂板作為隔斷板。
1。 Fireproof board: it is generally recommended to use glass magnesium board with thickness greater than 6mm as partition board.
2.配件：6毫米以上的床單固定在車架的龍骨上。采用3.5200毫米的沉頭螺釘固定，釘頭在板面上下方0.5毫米處，確保光潔度光滑。
2. Accessories: bed sheets over 6mm are fixed on the keel of the frame. It is fixed with 3.5200mm countersunk head screws, and the nail head is 0.5mm above and below the plate surface to ensure smooth finish.
3.安裝：開始安裝時，必須標記并標記龍骨的確切位置。垂直龍骨之間的距離為450-600mm。墻壁和門窗側面的接縫應安裝額外的龍骨。如果墻的高度大于2440mm，則必須在板的接頭處安裝支撐龍骨。
3. Installation: at the beginning of installation, the exact position of the keel must be marked and marked. The distance between the centers of vertical keel is 450-600mm. Additional keel shall be installed at the joints on the sides of walls and doors and windows. If the height of the wall is greater than 2440mm, a supporting keel must be installed at the joint of the plate.
4。板間距：相鄰板之間的間隙為4-6mm。板與地面之間的間隙必須為5mm。螺釘安裝距為150mm，距板邊10mm，距板角30mm。
4。 Plate spacing: the gap between adjacent plates is 4-6mm. The gap between the plate and the ground must be 5mm. The screw installation center distance is 150mm, 10mm from the plate edge and 30mm from the plate angle.
5.懸掛：懸掛廁所或廚房等重物時，必須用木板或龍骨加固，以免損壞。
5. Hanging: when hanging heavy objects such as toilets or kitchens, they must be reinforced with boards or keels to avoid damage.
6.接縫處理：在安裝過程中，板和板留有4-6mm的間隙。用107膠水或超級膠水混合后，用刮刀涂抹刀片和間隙，然后用紙帶或造型膠帶粘貼并壓平。
6. Joint treatment: during installation, 4-6mm gap shall be reserved between the plate and the plate. After mixing with 107 glue or super glue, smear the blade and gap with a scraper, and then paste and flatten with paper tape or modeling tape.
7。油漆裝飾：可采用噴涂、刷涂或滾涂，但刷涂時必須參照油漆的有關說明。
7。 Paint decoration: spraying, brushing or rolling can be adopted, but the relevant instructions of paint must be referred to when brushing.
8.裝飾瓷磚：在浴室、衛生間、廚房、地下室等潮濕處安裝時，面板上的瓷磚和龍骨之間的距離必須縮短到400毫米。每三片墻（約3.6毫米左右）必須有拉伸接縫。
8. Decorative ceramic tile: when installing in wet places such as bathroom, toilet, kitchen and basement, the distance between the ceramic tile on the panel and the keel must be shortened to 400mm. Every three walls (about 3.6mm) must have tensile joints.
9.隔音墻：如果墻體具有很高的隔音效果，墻壁和板材必須緊密封閉，礦物棉應填入空墻。如果龍骨兩側由兩個不同厚度的板制成，則隔室的效果更好。
9. Sound insulation wall: if the wall has high sound insulation effect, the wall and plate must be tightly closed, and mineral wool shall be filled into the empty wall. If both sides of the keel are made of two plates of different thickness, the effect of the compartment is better.
10。防沖擊墻：建議選用8毫米以上的防火板或單層防火板。第二塊板用較長的螺絲加固。該方法可提高材料的抗沖擊、隔熱、隔聲、耐火性能。
10。 Anti impact wall: it is recommended to use fireproof board or single-layer fireproof board more than 8mm. The second plate is reinforced with longer screws. This method can improve the impact resistance, heat insulation, sound insulation and fire resistance of the material.
上一篇：為什么復合墻板越來越暢銷呢？
下一篇：在選擇防火板的款式搭配時需要注意什么？
分類導航
Related products相關新聞
產品銷售熱線：13165128506
技術方案咨詢：18560211715
倉庫地址：山東省濟南市天橋區金鑫產業園303倉庫